Xylem.Common.Hardware.WaterMeter.Genesis.DataPackages
Stream record for calibration on channel
new record from Stream
new record from Stream
Ctor with base record
base record
base record
Register witch has updated
New Value in Register
EventArgs for Request Responses
Request response from meter
Streaming record for protocol M (information about bend detection and correction)
The status of the U0 detection for this measurement
Status okay
Error code as defined by field name
Error code as defined by field name
Error code as defined by field name
Error code as defined by field name
An enum describing the installation type detected
Installation type code as defined by field name
Installation type code as defined by field name
Installation type code as defined by field name
Status of U0 Bend detection
Installation type code
The proportion of the installation correction to apply based on the detected
installation. 100% == 0x8000
The default proportion of the installation correction to apply based on the
detected installation. 100% == 0x8000
Scale for correction factor to apply to convert it to percentage value 100% == 0x8000
The volume in internal units before correction applied
The volume in internal units after correction applied
Get result as string
hold streaming record for protocol H (contains calibration record)
record validation
total time of flight in seconds
delta time of flight in seconds
total time of flight in cordonel units
delta time of flight in cordonel units
volume scale (default: 1024) means
1024digits = 1ml
volume factor to convert raw to m³
uses 1E-6 (ml to m³) / VolumeScaleRawPerMl
raw volume between two samples
calculated out of dRawVolume * VolumeFactorRawToQm .
in cubic meters
accumulated raw volume
sample interval between two samples in seconds
high threshold amplitude in V
low threshold amplitude in V
high ratio for pulse width
low ratio for pulse width
raw temperature
temperature scale
calculated temperature in degree C
Get result as string
struct to hold Led record for protocol F (contains measurement record)
Get result as string
All parameters needed for radio setup
Pcb identification
Serial number
Radio address
Power level
Power level option
New code for impedance
Impedance code option
Encryption key
Frequency offset
Register address and value to DB
Address
Value
Temperature Time Of Flight calculation
Reference data
Reference temperature
Time Of Flight